Hi All,
l am still looking for pictures or drawings or even a good description of
the lower door seal location for a '62 TR-3? The middle part is obvious as
there are holes for the metal clips. At the forward end there's another hole
of
the same size but set further inboard and part way up the vertical section
of the inner panel, just below the mounting points for the lower door hinge,
so if it is for the seal, the seal would be bending upward around the curve of
the inner panel and away from the outer door skin. Where the rear portion
should stop is even less obvious. The holes stop about 3-4 inches from the
rear
bottom corner of the outer door skin. Isn't that a rather large gap?
I have had three other people ask me to forward any pictures I get as they
are wondering the same thing. Thanks for any help you can provide!
Gary B
**************New MapQuest Local shows what's happening at your destination.
Dining, Movies, Events, News & more. Try it out!
(http://local.mapquest.com/?ncid=emlcntnew00000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|