As long as it's oversized, it can be cut down to the proper size for
not a lot of money.
- Tony D
At 10:41 AM 10/1/2008, Randall wrote:
> > But if this number is quite far off what is expected for
> > those kits, then we know something.
>
>Unfortunately, the diameter for the conversion kit is closer to 2.520. So
>the conversion seal isn't going to work with the MF crank, unless it's
>modified.
>
>But .150 or so per side isn't all that much, so it's still possible the MF
>seal will fit into the conversion housing.
>
>Randall
>_______________________________________________
>
>Support Team.Net http://www.team.net/donate.html
>
>This list supported in part by the Vintage Triumph Register
>http://www.vtr.org
>
>
>Triumphs@autox.team.net
>http://autox.team.net/mailman/listinfo/triumphs
>
>You are subscribed as tony@tonydrews.com
>
>http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|