A couple of questions:
1. Is the rubber boot seal glued into place? Mine won't stay on as I
expected it to. If so, what adhesive?
2. Same question for the spare cover seal.
3. What material is recommended as a seal between the inner and outer front
wings?
4. Is this to be used between the inner and outer rear wings as well?
5. The rubber gas cap seal provided was a grooved arrangement that slipped
over the edge of the body panel hole. Unfortunately, the threaded male part
of the chrome cap would not fit through the remaining hole to thread into the
brass under panel piece. I assembled without for the time being. The part
ordered appeared to be correct for my car. Do I have the incorrect gas cap
assembly? I don't care to change the gas cap, just provide a rubber seal.
Does anyone have a "known to work" technique for covering the dogleg cap
just behind the doors? The supplied kit has leather provided. I originally
covered mine with vinyl using 3M spray trim adhesive and was quite happy with
the results until the car sat in the sun and the adhesive let go at the stress
points. This is a do over.
TIA
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
**************Psssst...Have you heard the news? There's a new fashion blog,
plus the latest fall trends and hair styles at StyleList.com.
(http://www.stylelist.com/trends?ncid=aolsty00050000000014)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|