Tom;
You old retired guys don't have anything better to do so install them
without the cutouts and see what happens. If they still shriek, pull them
out as start all over. Let me know how you make out so that when I do the
job, I can do it right the first time. :^)
Joe
-----Original Message-----
From: triumphs-bounces+trglory=comcast.net@autox.team.net
[mailto:triumphs-bounces+trglory=comcast.net@autox.team.net] On Behalf Of
Tom Note
Sent: Thursday, September 11, 2008 1:04 PM
To: Randall; 'TR List'
Subject: Re: [TR] Anti squeal shims
----- Original Message -----
From: "Randall" <tr3driver@ca.rr.com>
To: "'TR List'" <triumphs@autox.team.net>
Sent: Thursday, September 11, 2008 11:29 AM
Subject: Re: [TR] Anti squeal shims
>> I believe shims usually
>> have
>> a "D" shaped cutout slightly smaller than half the diameter of the
>> piston.
>> Are these cutouts necessary , or would a plain shim work as well?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|