Hi All
I installed the new pistons this evening in the new sleaves. All the rings
gapped to .015 or .016
When I put the Crank in eveything rotated nice an smoothly, As I put each
piston in it got much harder to rotate everything, and after the last piston
was installed it is now almost imposible to rotate anything. It really takes a
lot of force to move a piston down or rotate the crank.
On a new install how difficult should it be for all this to move? If I have to
take it apart now would be a good time to do it.
Thanks
Tom
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|