> One last question I had is attaching the optical brackets.
> Use existing holes or make new ones?
We found a hole that worked, but I don't recall which one. I had to cut one
of the brackets tho, to make it fit on my TR3A.
> Do you keep points plate in or take out?
Normally, keep it. For a 69 TR6, you'll need it to retain the vacuum
advance/retard operation. Don't forget that it moves both ways, so there
needs to be some slack in the wires.
> And i'm assuming the optical scanner
> gets attached to be "tripped" at the same location that the
> points get tripped?
Right. Check out "Optical Trigger Adjustment Procedure" starting on page 13
of the Crane instructions (unless they've been updated from the 10/2000
version on my hard drive).
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|