I have been looking at the linkage on the H6 carbs of my 57 TR3 and
noticed that there is a lot of worn pieces that need to be replaced.
It is easy to identify most of the worn parts but I can not tell for
sure how bad the jet lever has worn.
The jet lever is the L shaped brass piece that connects to the jet and
on the front carb, the choke cable connects to a bracket on it.
My question is how large should the hole be at the base of the L where
it connects to the choke cable bracket?
The pin at this location is about 1/8 inch in diameter however the hole
in the lever is about 3/8 inch.
Is the hole suppose to be larger or has this just worn itself away? The
rear carb bracket is just as loose as the front one.
As most of the openings appear to be oversized due to wear, I was
thinking of filling them in and drilling them out to the correct size.
Larry
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|