Darrell
TS21130L's original beading below the tail lamps bent flush at the bottom
and was secured by small screws through the beading into the sheet metal.
Don't know about later TR3s.
Ed Woods
> Hey List,
> Going over the Ole lady TR3B and I am bugged by the aluminum finisher from
> the bottom of the rear wings to the tail light. At the tail light there
> is a
> 1/4'' gap between the finisher and the tail light base? At the bottom of
> the
> wings there is a right angle so that's how it is going to fit unless it is
> backwards with the gap meant to be at the bottom????
>
> Evidently I had some homemade braces for the seat belt anchors within the
> rear wheel wells. Those were replaced by some large round washers and
> left
> unpainted. Rather anal, I'm OK with the round washers but not body color
> sort
> of bugs me. But if the dealers put these on????
>
> Thanks for any comments,
> Darrell
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|