Bill and Kirk,
Let me know if you guys find one. I need a new seal for my 78 FHC and I
would also like a new large spongy seal as well. If we are going to
do one seal we might as well do both of them.
Richard
78 FHC
Huntsville, AL
----- Original Message -----
From: "Bill" <triplesn8s@neo.rr.com>
To: "K YONKER" <yandainc@msn.com>
Cc: "Flying Wedges" <tr8@mercury.lcs.mit.edu>
Sent: Saturday, July 19, 2008 1:04 PM
Subject: Re: [Wedge] Fuel (Gas) Cap Seal
>I need one too. If we got a few people together it would be easy to make
>a run of them. The material & time isn't much. The money is in the
>set-up charge.
>
> K YONKER wrote:
>> I recall this might have been recently discussed,
>> however is there any current availability of the rubber
>> seal used on the later years, small sized fuel caps?
>> I am not referring to the cap's large, spongy seal which
>> I presume is/was utilized as a water/moisture barrier. I am
>> referring to the seal fitted on the cap that provides
>> a seal between the cap and the fill pipe. I can't seem to
>> find a part number.....
>>
>> TIA for any and all replies.
>>
>> Rgds,
>>
>> Kirk Yonker
>> 1981 Triumph TR8 fi non a/c
>> Seattle
>> --
>> Forwarded via the TR7/8 mailing list. Please send administrative requests
>> to the majordomo at tr8-request@mercury.lcs.mit.edu
> --
> Forwarded via the TR7/8 mailing list. Please send administrative requests
> to the majordomo at tr8-request@mercury.lcs.mit.edu
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|