For the first time ever I've greased my newly rebuilt front end on my TR3.
Finally I've seen the usefulness of the (now) plump rubber seals at the outer
end of the lower wishbones. Now these seals are plump with grease and even
where one broke, I'm confident that by wrapping and supporting it with black
electrical tape that it will also do a good job of containing the grease.
However, following the diagram in Moss's catalog, I also used the black
rubber seals for the INNER end of the lower wishbones. But their is NO grease
fittings for these locations. Thus those seals are loose and rather lifeless.
Is this the way its suppose to be?
Thanks,
Paul Dorsey, 60 TR3 (TS71318L)
--
I am using the free version of SPAMfighter for private users.
It has removed 698 spam emails to date.
Paying users do not have this message in their emails.
Get the free SPAMfighter here: http://www.spamfighter.com/len
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|