I had a hard time with initial install of the seat tracks myself, but was able
to squeeze the studs into the holes in the new seat pans from Roadster Factory.
Any chance your tracks have bent studs?
Terry
-------------- Original message --------------
From: DLylis@aol.com
> I rebuilt the motor and the tranny and added an over drive and made all my
> patch panels and welded them into place and finished the body. What can't I
> figure out? How to put the seats in. I replaced the drivers side floorpan
> and the passenger is original. I bolted the seat tracks to the floor in the
> prescribed holes and the distance between the studs to which the seats bolt
>is
> 11 1/2" but the holes in the seat pan are 11". They came out of this car.
> Which side does the seat lever go on? I have bolted and unbolted and switched
> around and put them in backwards but can't come up with 11". I am about to
> drill new holes in the seat pan but I know that is just wrong!
>
> Yes Terry, this is the guy who was telling you how to fix your idle but
> can't figure out how to put his seats in.
>
> David Lylis
> 69 TR6 CC26160L
> 60 TR3A TS74461LO
>
>
>
> **************Vote for your city's best dining and nightlife. City's Best
> 2008. (http://citysbest.aol.com?ncid=aolacg00050000000102)
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as terryrs@comcast.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|