On Sunday 01 June 2008 09:16 pm, DLylis@aol.com wrote:
> In a message dated 6/1/2008 8:05:02 PM Eastern Standard Time,
>
> yellowtr@adelphia.net writes:
> > Do you have the std 3 3A intake manifold or the later TR4A version? The
> > 4A intake is a bit longer than the 3 and 4 intake. If you have the 4A
> > intake, this could be where your problem is.
>
> My manifold is 3 3/4" straight line measure from the top edge of the motor
> side flange to the top edge of the filter side flange.
>
>
That is the std 3 intake manifold.
How thick are these air filters anyway? I am guessing just the front one hits
the fender well? Maybe you need to carefully dent in the fender well to
accomodate the filters?
I did this years ago when fitting the 4A intake manifold + the 4A header
exhaust manifold.
Not the best solution but maybe the only one to use if you really want to use
the K & Ns.
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|