In terms of lubrication for the various components of my TR3A, I have been
following the advice from the List as follows. Maybe it's a good time to send
it out for any new people I've been daily driving my ground up TR3A
restoration for two years following this and can't be happier, except with the
wire wheel decision.
OD tranny oil: Valvoline 20-50 racing oil. "Ken Gilanders at British Frame
and Engine ran it in his own TR2, the "Red Rocket" for 5 years, and then tore
the tranny down just to see the results. He said it looked brand new inside."
Engine oil: Break-in periods are a bit debatable, but many pefer non-synthetic
for 500 miles, and this can be either non-detergent or detergent. I ran
non-detergent 30 weight. After break in, Valvoline full synthetic is good.
Redline is good too, just more difficult to get (in New Hampshire).
Differential: Valvoline full synthetic gear oil, "which is rated something
like 75w90.
Steering Box: Valvoline full synthetic gear oil, as above.
Dashpots: Straight 20 weight. "Experiment if you want: too thin makes the
engine seem sluggish on acceleration, while too thick makes it resond so quick
that i's hart to control smoothly. ...Your engine may act differently"
Trunnions: for the TR3A "only grease. Later cars have completely different
trunnions designed to hold oil.
Cables: "Dry Film" MoS2 lubricant.
Wire Wheel Splines: Permatex copper anti-seize lubricant (#133A or #09128).
On the wire wheels, I'm not particularly happy. I did have a wire wheel that I
had to beat off with a BFH this spring. I'm wondering if grease would be
better?
Your experience may vary.
Terry Smith, TR3A
New Hampshire
-------------- Original message --------------
From: "Randall" <tr3driver@ca.rr.com>
> > > Not if you use Penrite "Steering box lube"
> >
> > Where do you get this?
>
> I don't, as I feel using "almost grease" will make the car steer abnormally
> hard. Had a non-LBC once where the DPO had filled the worm-type steering
> with grease, and after a few months of driving it, my biceps were too big
> for my shirt sleeves !
>
> However, one place it's available in the US is :
> http://www.restorationstuff.com
>
> They claim to be exclusive distributor for Penrite in the US.
>
> Randall
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as terryrs@comcast.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|