-------------- Original message --------------
From: David Ljung Madison <team.net@daveola.com>
> When I extended the driveshaft to the correct length to have enough
> play between the output flange and the rear seal, I was fortunate on
> my car that this was the full extension of the driveshaft. So
> once I put the locking collar on, the driveshaft had no slip in it
> (presuming the locking collar holds :).
Here is what I think seems to be happening. The locking collar is supposed to
hold the driveshaft in the fully open position. You grab the 2 ends of the
driveshaft, pull them with reasonable force to what appears to be full
extension, and then you put on the locking collar. However, in my case, after
discussing this with Bob Danielson, I found that I was able to pull the
driveshaft out further than what I thought was fully extended. In fact with the
locking collar and dust cap in place, I was able to pull the 2 pieces of the
driveshaft apart. If the forces of driving extend the driveshaft past "fully
extended" in the car, the rear seal clearance is going to fall below the
minimum and someone is going to lose a rear seal and ultimately a Toyota 5
speed.
YMMV.
THANKS, Bob.
Irv Korey
74 TR6 CF22767U
Highland Park, IL
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|