Thank you for your reply Randall.
Ref. I found said prod. 2-114 was:
I.D 5/8, O.D. 13/16, C.S 3/32 Note also said originals did not like Ethanol.
Since one is only weeping I'd like to find replacements FIRST.
Weather is getting real nice.
I'll take a look at Harbor Freight
Bob
----- Original Message -----
From: "Randall" <tr3driver@ca.rr.com>
To: "'Bob Peglow'" <rpeglow@optonline.net>; <triumphs@autox.team.net>
Sent: Saturday, May 24, 2008 8:25 AM
Subject: RE: [TR] Stromberg plug o-rings
> > I have searched and found reference to the o-ring for
> > Stromberg bowl bottom plug to be style/type 2-114, correct?
>
> Can't find my note at the moment, but I'm pretty sure that's not the right
> number. -114 would indicate a 5/8" od, and the bore in the rod is much
> smaller than that.
>
> > One recommendation said use Vitron only, another said
> > Ethylene... only.
>
> Viton would work I believe; but I used ordinary Buna-N (nitrile rubber) as
I
> believe that's what the originals were (and what I had on hand). EPDM/EPR
> (Ethylene Propylene whatever) is definitely the wrong thing, IMO, as it
has
> poor resistance to petroleum oils.
> You can read more about O-ring materials at any number of web sites,
> including MMC and
> http://www.epm.com/material_guide.htm
>
> > What's the latest......... and where can I get them please?
>
> ISTR Mine came from Harbor Freight, in one of these kits
> http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=2901
>
> Bought on sale for 1/2 price; figuring that even one O-ring used from it
> would pay for the kit. It's been handy many times since then. In fact,
> just a few days ago, I tried several O-rings from the kit until I found
the
> one that fit my bearing extractor (holds the tip to the forcing screw).
>
> Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|