To the list,
My TR6 has a rough, lumpy idle. I'm going through all of the standard
troubleshooting steps to identify and correct any problems in an attempt to
smooth out the idle. I measured 11 inches on my vacuum gauge and believe it is
too low for idle vacuum.
If anyone has measured the vacuum on a smooth idling TR6, could you post what
your measurement was? I took my measurement from the 1/4 inch nipple which is
part of the brake booster nipple on the intake manifold.
thanks
Robert
74 TR6
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|