On Sunday 11 May 2008 09:35 am, terryrs@comcast.net wrote:
> Am I missing something? The valve adjusting nuts on the TR3A rocker arms
> seem a bit small for a half inch wrench, yet don't fit metric either.
> Every time I adjust the valves, I bugger up the corners of the nuts a bit
> more. I'd like to replace them with new from a local supplier if possible,
> just to save shipping.
>
> Terry Smith, '59 TR3A
> New Hampshire
Terry,
Try using a 6 point box wrench. 1/2 " is the correct size.
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|