Paul,
Just as a heads up on that clutch line. When I got my 3A the Slave was a
bit funky. I had installed a new slave on my TR6 just prior to puting in the
HVDA conversion withthe McLeod hydraulic bearing so I had this slave sitting
on the shelf. I put it in my 3A and it works fine but I seem to recall that
the thread on the hydraulic fitting from line to slave is not the same. I had
to change the fitting on the end of the hose to match the TR6 slave
cylinder. Be careful upon reassembly and don't force it. You can't change to
a TR6
hose because the other end would then be wrong.
This was a couple of years ago and I am pretty sure that is the story.
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
**************Wondering what's for Dinner Tonight? Get new twists on family
favorites at AOL Food.
(http://food.aol.com/dinner-tonight?NCID=aolfod00030000000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|