I called TRF to order some grommets and found they had a gasket for the
right-side steering column hole (my '58 is LHD). I was told there is a part
number for the blanking plate: 601962 but they do not and have never had
them. Then I called MM and was told the part number for the gasket: 603346
is a solid piece and serves as the blanking plate.
So, who is correct? If TRF is right are they any suggestions as to where I
may get this plate? If MM is correct then why do I have two holes with
threaded spring-clips on either side of the hole in my firewall (maybe a DIY
from the PO?)
TeriAnn has a very nice firewall grommet diagram for the post-60,000 TR3s on
her site, does such a diagram exist for the pre-60,000 units as well?
Thanks to all,
Bill B
'58 TR-3A TS/30766 L
'59 TR-3A TS/64974 LO
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|