Here are the instructions that came with my Amco top years ago -- but I
would only consider them a starting point. For a good fit you almost have
to do some trial and error as I think there are variations among top
manufacturers, esp where that seam that corresponds with the rearmost rib
ends up sitting.
http://www.cybertrails.com/~ahwahnee/top-webbing.GIF
Some leave that rear bow unattached to the webbing to make it easier to
erect a tight top, this also simplifies the placement as it becomes somewhat
adjustable.
I finally did mine using lengths of nylon rope/cord that I looped around the
bows for multiple trial & error fits until I got what I wanted, then
measured and installed the webbing.
I think you want the bows to be a little bit high so they get pulled down
(and the webbing pulled taut) as you pop the 'knee' back to fully install
the top.
Geo
----- Original Message -----
From: <L1J1S@aol.com>
To: <triumphs@autox.team.net>
Sent: Friday, April 25, 2008 5:39 PM
Subject: [TR] tr3-a bow
>> can anyone tell me if i am on the money or ,,,,,,,,.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|