> A friend of mine told me I
> should have the exhaust manifold surfaced before re-assembling. It is not
> rusted, but not perfectly clean either. What are your thoughts
I'd check it for being reasonably flat, with a straight edge (like a
carpenter's square). If it's not obviously warped, clean up the mating surface
a bit with a file, and put it together. If it is obviously warped, then either
get it machined or pick up another manifold.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|