In a message dated 4/7/2008 12:36:13 P.M. Pacific Daylight Time,
dorpaul@bellsouth.net writes:
Although neither horn is hooked up to my TR3, they don't really make a
'blare'
at all when I hold their two wires to the positive and negative posts of my
12v family car battery. If i reverse the wires/posts (reverse the polarity)
they still don't blow.
I am trying them individually. Also, I think when the connection is being
made, they do, however, make the hiss echo that a phonograph record needle
makes (before or after the song- but not as loud). What am I forgetting?
Paul,
What I have had to do is this:
1. Remove cover of horn,
2. Use some fine emery cloth to clean the contacts.
3. Loosen screws which adjust the points while applying power until you
habvethe best horn sound. Tighten locking nut on adjusting screw.
Good Luck!
Mike Moore
**************Planning your summer road trip? Check out AOL Travel Guides.
(http://travel.aol.com/travel-guide/united-states?ncid=aoltrv00030000000016)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|