> Yes, this is the one that Paul is referring to. The one end
> bolts into the stiffening panel (item #19, page 67 of Moss
> catalog) caged nut. What I am not clear of is how does the
> other end that is bent at a right angle fit to the fender?
Are you guys possibly talking about P/N 602167, "Clamp, rear wing fixing" ??
This is a short strip of metal, about 1/2" wide and 3-1/2" long with a
captive nut at one end, and a sharp right angle at the other end. The
angled part is no more than 1/4". It doesn't really connect to anything;
the captive nut gets the rearmost truss-headed screw from the trunk lid
opening, while the angle presses against the lip of the rear fender at the
very back. It basically clamps the last little bit of the fender to the
rear apron.
http://www.zeni.net/trf/miniTR2TR3/33.php?s_wt=1680&s_ht=1050
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|