I just did my TR3 spare tire compartment seal, and I had to re-adjust the lock
taps in spare tire compartment to allow the locking mechanism to work. You
will have to bend them slightly outwards (towards the rear) to make them lock
properly because of the new seal.
Ibsen
----- Original Message -----
From: L1J1S@aol.com
To: triumphs@autox.team.net
Sent: Sunday, March 16, 2008 2:44 PM
Subject: [TR] seal-spare tire well lid tr3
hello, i need to put on the rubber seal for the spare tire lid on my tr3-a.
the rubber has a square section that goes inside on the body of the car.
there
is a lip on the rubber, the question is which side on the body does the lip
face, the outer part of the frame or the inner part of the frame. i tried it
on
the outside part of the frame and i could not lock up the spare tire cover.
larry schwartz 1960 tr3-a
**************It's Tax Time! Get tips, forms, and advice on AOL Money &
Finance. (http://money.aol.com/tax?NCID=aolprf00030000000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as flashtr3@cox.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|