In a message dated 3/12/2008 12:54:10 P.M. Eastern Daylight Time,
nwolf@u.washington.edu writes:
1. Which type of boot support rod do you have (folding or sliding)? If
folding, is the lower bracket welded to the inner fender, or just to the boot
lip?
2. Is your spare tire anchored to a stamped steel loop that's welded to the
boot floor, or a hook that's bolted to the frame crossmember?
3. Is there a small tab (for holding wire) welded to the horizontal surface
of the bulkhead immediately forward of your voltage regulator?
4. Does your bonnet release mechanism have an ear on the right side that
sticks up about an inch above everything else and then folds over toward the
right side of the car?
5. Do your taillight lenses have concentric circles over the bulbs (L669) or
vertical bars (L799)?
1962 TR4 CT 5521 LO CKD or SKD?
1. Sliding & welded to the inner wing.
2. hook bolted to the crossmember.
3. Yes, the tab is present
4. No, but I have seen those on early Fours
5. Circles, Note that the original lenses may have been amber & red with
circles as seen on pictures of the unrestored car.
Cheers,
Darrell
Long Bubble Bonnet Too, which has all the appearance of being original to
the car from pictures and testimony from the two previous owners.
**************It's Tax Time! Get tips, forms, and advice on AOL Money &
Finance. (http://money.aol.com/tax?NCID=aolprf00030000000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|