Well, I tried the lead free roll solder and with a paste flux it did not
work very well as penetration and adhesion was not great. I then used a
liquid
flux called Stay-Clean and the solder flowed well and adhesion is great. The
joint ground out to a nice feather edge. I have a couple of more places to
fix and I am done.
If you are looking for a low heat solution the tin/copper lead free works
well although it wants to be either liquid or solid so spreading is not a good
option but for small areas it seems to be good.
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
**************It's Tax Time! Get tips, forms, and advice on AOL Money &
Finance. (http://money.aol.com/tax?NCID=aolprf00030000000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|