Removal is very straight forward. Just make sure you get all the bolts. Then
with a helper lift it out by the cross brace above the radiator.
Installation can be more tedious. You have to get your fender beads seated.
I work from top to bottom tightening bolts as I go. I have a problem with the
lower lip aligning with the fenders. So I have moved my bumper brackets to
their rear position. Now I install the bumper bolts over large washers and
tighten them. This pulls the lip of the apron into alignment with the
fenders. I finish tightening all the bolts and it is done.
Best regards,
Tom
_________________________________________________________________
Helping your favorite cause is as easy as instant messaging. You IM, we give.
http://im.live.com/Messenger/IM/Home/?source=text_hotmail_join
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|