There are probably lots of places you could get these washers but Pierce
Manifold in Gilroy California will have them...
http://www.piercemanifolds.com. They are the largest distributor of Weber
carburetors in the USA. NFI etc.
Mike Denman
----- Original Message -----
From: "Chuck Arnold" <triosan@gmail.com>
To: "Friends" <fot@autox.team.net>; "Triumph" <6pack@autox.team.net>;
"Triumph Email List" <triumphs@autox.team.net>
Sent: Monday, February 25, 2008 10:45 AM
Subject: [TR] Weber DCOE fuel inlet parts
>I have a set of triple Weber DCOEs. The fiber/cotton?? washers surrounding
> the banjo bolts on the fuel inlets have deteriorated to the point they
> leak. I cannot find replacement parts. The outer one is 15mm, but crush
> washers come only in14 [too small] and 16 [too big]. The Carb supplier I
> usually use says they are not available. Does any one have a source?
>
> --
> Chuck Arnold
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as mikedenman@sbcglobal.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|