I bought a pneumatic grease gun - my old workshop lever grease gun finally
failed from being cross threaded once too often. This pneumatic grease gun
is a Chinese special from Harbor Freight. The instructions say that if the
gun does not pump grease to "prime" the gun. So far, I have not had any
luck priming the gun. Anyone out there have one of these cheap pneumatic
grease guns? Did you have a problem getting it to start pumping? Is this
going to be an issue w/ every change in grease cartridge or is this a one
time problem (if this is going to be an every time problem, I'll go back to
the lever style of gun)?
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|