I acquired a crank that already had the scroll modified for use with one
of the lip type seal conversion kits. The diameter is 2.567". Both Moss
and BPNW sell kits that require a diameter of 63.5mm (or 2.502"). Does
someone else sell a different kit that user a larger diameter seal or
was this done by mistake? I haven't tried TRF or Victoria British yet.
Searching through old posts, I found that there were some improper
dimension spec's supplied early on. I get the impression that they were
too small rather than too big.
I hate to take the crank in just to have the seal surface reduced by
another .065" so if anyone knows of a kit that matches this, I would
greatly appreciate hearing about it.
Thanks!
Mike
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|