Or try your local motorcycle shop as these are used to make cable ends when
that can't be soldered.
Bill B
'58 TR-3A TS/30766 L
The car is in a 'zillion' pieces... but I think about it every day!
-----Original Message-----
From: triumphs-bounces+wbeech=flash.net@autox.team.net
[mailto:triumphs-bounces+wbeech=flash.net@autox.team.net] On Behalf Of Bob
Labuz
Sent: Monday, February 18, 2008 4:13 PM
To: 308gtsi@adelphia.net; Triumph Email List
Subject: Re: [TR] Scuttle vent rod connector
On Monday 18 February 2008 04:53 pm, Brian Induni wrote:
> Thanks Bob, but I have the rod. What I need is the small, obscure
> connector to attach the rod to the lever under the dash. I image it
> looks something like a cable stop, but I'm not sure.
>
> Brian
>
Brian,
Sorry, mis read your post.
Yeah I didnt have that little gizmo either so I made one out of a similar
part that is in the heater water control.
Take a look at Moss part # 473-070.
I had a few of these lying around and it fit just fine after I drilled out
the cable hole a bit.
The parts manual lists this part as 612219. TRF says they have it.
about 2 bucks.
Sorry for the error post!
Bob
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as wbeech@flash.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|