triumphs
[Top] [All Lists]

Re: [TR] Accelerator Shaft Bearing/Bushing

To: "Bob Danielson" <75TR6@tr6.danielsonfamily.org>
Subject: Re: [TR] Accelerator Shaft Bearing/Bushing
From: "Ibsen Dow" <flashtr3@cox.net>
Date: Fri, 1 Feb 2008 09:13:27 -0800
Hi Bob,
I re-did my accelerator shaft & bearing assy last fall on my TR3. I had the
carpet out of the way. I had to install the nylon bearings loosely on the
shaft after you thread the accelerator pedal into engine compartment.
Then you can tighten down the nylon bushing holders to the firewall.
The hardest part I had, was when I powder-coated the accelerator shaft and
made the diameter of the shaft thicker. I then had to grind down the inside
dia. of the brass bushing that is used to hold the accelerator shaft in place
& keep it from sliding.
There was no problem with dia of the nylon bushing, only the brass bushings.
(keeper or stop)
Ibsen
  ----- Original Message -----
  From: Bob Danielson
  To: Triumphs@autox.team.net ; 6pack@autox.team.net
  Sent: Thursday, January 31, 2008 3:11 PM
  Subject: [TR] Accelerator Shaft Bearing/Bushing


  I've heard horror stories about installing these nylon shaft bearings #19
  (http://tinyurl.com/yvq8qf) so I was very pleased when they went in without
  too much trouble. The problem now is getting the accelerator shaft back
  through them as there isn't enough room in the driver's foot well to
  accommodate the length of the shaft. Before I start tearing things apart,
  does removing the interior carpeted panel free up room or do I have to
  remove the bearing from the car, slide it over the shaft and work it back
on
  to the car once the shaft is in place?

  Thanks

  Bob

  Bob Danielson
  1975 TR6 CF38503U
  Running w/ Throttle Body Injection
  http://tr6.danielsonfamily.org



  Checked by AVG.
  Version: 7.5.516 / Virus Database: 269.19.17/1252 - Release Date: 1/30/2008
  8:51 PM



-----------------------------------------------------------------------------
-


  _______________________________________________

  Support Team.Net  http://www.team.net/donate.html

  This list supported in part by the Vintage Triumph Register
  http://www.vtr.org


  Triumphs@autox.team.net
  http://autox.team.net/mailman/listinfo/triumphs

  You are subscribed as flashtr3@cox.net

  http://www.team.net/archive
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [TR] Accelerator Shaft Bearing/Bushing, Ibsen Dow <=