Even though I have never driven my TR3, I need to again remove a vertical link
(because I had forgotten to install the backing plate/dust plate for one front
wheel.) One of the four caliper bracket/vertical link bolts, the one that
holds on the dust plate, had been too short, and that's my excuse for
forgetting the dust plate.
However, on attempting to reinstall a longer bolt, I met with considerable
tightening resistance. Greater even than it's 25 ft.lb. torque specification.
I think this bolt was a 3/8" fine thread. Should I just continue tightening
it? On the other front wheel, this bolt goes clear through this caliper
bracket/vertical link.
Thanks,
Paul Dorsey
60 TR3
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|