When the snow clears a bit this spring, I'd like to beef up the alternator
conversion by welding in the pipe between the ears of the bracket. This
measures to be 3/8ths ID, 1/2 OD and about 4 inches long.
How does one source that? Haven't found it at Lowes or HD, and I'd hate to buy
a 24 inch section, but will if I have to.
Also, I'd like to use the 2" x 2" steel box to enclose the flange on the
alternator to complete the set up. Any source ideas there?
Remember Claire's "Where's the beef?" I don't want another problem with a
breaking bracket on the alternator.
One thing I CAN promise, the weld on this bracket will be the ugliest piece of
art you've ever seen!
Appreciation in advance....
Terry Smith ('59 TR3A pretty much stock)
New Hampshire (where the pollsters have finally stopped calling, and where my
toes are healing from tripping over hopefuls)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|