I've used the Caswell Copy Cad kit with great success. It's expensive
to get started, as it's best to have a variable power suppy to do the
plating. You can just plate and it will leave a dull silver zinc like
cadmium plate, or you can add a brightener and get an almost chrome
shine to the plate. You can also dip in yellow chromate dye after
plating for yellow zinc parts. If you've just got a bucket of bolts to
be done, it would be cheaper and much easier to go commercial . If you
watch ebay, you can often pick up a power supply pretty cheap. As with
any plating, the preparation the part receives is the most important
part. Check out caswell's web site. There's a great deal of information
there, and they are very helpful with problems. They also host a
plating forum online. John Mitchell 76 TR6 with lots of fresh
yellow zinc parts.
Dave Willner wrote:
> I'm thinking about improving the appearance of a lot of smaller hardware and
> odds and ends this winter and was wondering if anyone has any experience using
> any of the plating kits available today, I know Eastwoods sells a fairly
> inexpensive Tin-Zinc kit that seems to produce some pretty nice results. I've
> also looked at some of the cad plating systems, a bit more expensive but a
> real nice finish. Thanks
>
> Dave Willner
> Stroudsburg, PA
> 59 TR3A Apple Green
> 70 MGB BRG
> 70 BSA 441 Victor Special
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|