> I have installed a J type on an early tranny and the right
> angle drive that
> I got for the J type from TRF does not fit. It is a screw
> type and the one I
> have appears to be a press fit held on tot he case by a
> machine screw.
> Anyone know what I should be looking for?
I believe the adapter is TRF P/N NKC43; Moss 866-970. That should include
the clamp, but not the bolt.
Looks like you are also missing the seal around the shaft, TRF NKC105A; Moss
461-445.
But the drive gear looks to be usable. Drive ratio will almost certainly be
wrong unless you've changed the gears though, as the J-type TR6 used a
different speedo calibration than the earlier TRs (like your TR4) did. I
think to get the TR4 ratio, you'll need a 6-start gear inside the OD, plus a
15 tooth pinion.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|