I am doing the final fitting of my aluminum-tierod bar- that-goes between my
TR3's fenders. I had it installed to adjust the bonnet gaps, but, it came off
while working on my quasi-radiator.
the refitting of the tie-rod bar was difficult the first go-around. On
this occasion I have gotten 3 of the 4 bolts (nails are temporaily being used)
in. The one nail missing is toward the middle of the car.
I am wondering if there are any special places to lift for this to go in. Any
other advice is welcome.
Thanks,
Paul Dorsey 60 TR3
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
http://www.team.net/donate.html
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|