I needed humbling. When I tentatively laid my TR3A's bonnet ontop of it's
compartment, I saw huge side cracks between the bonnet and outer fenders! On
the front of one of the front fenders in the area where the front bumper, it
lacks 5/8", (surely this is too much?) I haven't attached the TR3A apron yet-
(would the apron reduce these gaps about 1/2" on each side?) Is this
tolerable or should I remove the fenders again?
One finicky place on both side's is where the scuttle's guttering meets
the outer fender's top trough. In both cases, I was successful in getting the
fender's trough on the inside and closest to the middle of the engine
compartment.
One front fender is also 1/4" or so too high. Tolerable for a daily
driver never wrecked or disassembeled before?
Thanks, Paul Dorsey 60 TR3A
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|