Check your rocker geometry. When a valve is half way open the rocker tip
should be at the middle of the valve stem. If this is not the case buy an
adjustable, screw adjuster on the top, and adjust it until the rocker tip is
in the proper position. Then measure the push rod and buy new push rods for
your engine that are the length of the adjustable one.
Best regards,
Tom
_________________________________________________________________
Peek-a-boo FREE Tricks & Treats for You!
http://www.reallivemoms.com?ocid=TXT_TAGHM&loc=us
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|