Eh Oh! Even though my TR3 has been off the homemade rotisserie for several
years, I am still working on it and never have a Triumph! However, something
about the rotisserie experience just hit me!
I believe i 'rotisserized' the chassis before doing this to the body.
When doing the chassis, I read where it was important to first put the single
pipe in place in the front of the engine cavity to hold the sides apart even
though the engine was not installed. I did this.
However, when rotisserizing the tub, I don't think I installed the tie member
(over the radiator). Is this necesary... essential? If it should have been
done, then where should I possibly inspect to see if stress has caused
any...well uh,...'stress'.?
Thanks,
Paul Dorsey
60 TR3
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|