I am not much of a perfectionist, but...
when I attempted to put the right-front-fender on over the inner fender, the
holes didn't quite line up. Oh, the hole's center was visable and completely
under the uppermost hole's cutout, but, it still lacked 1/4 - 3/8"of lining up
perfect. Need I be concerned?
Since I am now concerned with bodywork, is there any certain aspect of it that
demands closer attention than another?
Thanks,
Paul Dorsey
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|