I use a wire brush wheel on my power drill.
Joe C.
-----Original Message-----
From: triumphs-bounces+spitlist=cox.net@autox.team.net
[mailto:triumphs-bounces+spitlist=cox.net@autox.team.net] On Behalf Of sujit
roy
Sent: Tuesday, September 04, 2007 4:10 PM
To: Triumph List
Subject: [TR] removing gasket goo
The stags oil pan is not completely flat on the top that mounts to the
block. It like this ______/--------\____
What product will remove gasket goo? I've scraped off what I can with a
knife , but there is some stuff left on the sides which I can't get too
very easily
Sujit
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|