In a message dated 8/29/2007 6:02:53 PM Mountain Daylight Time,
TR250Driver@aol.com writes:
OK, hooked up a jumper cable from the left
tail light housing to the exhaust pipe and all lighting functions then
appear to
operate normally. Take off the cable and we go back to rear end Disco
Lights! What would be next? Remove the whole light assembly? Need a Wedge
Type
Guy here. Not seeing any real "Ground Connections" to clean up. Not
interested in tearing Ugly's whole rear end up unless it is required.
Thanks a Bunch,
Darrell
I cured a Fiat with this problem many years ago by using short lengths of
wire from a ground to to a screw that held the lamps in. Wrapped around the
screw and tightend down, and the lights were grounded. I had to do both front
and back on the Fiat.
Robert B. Houston
Texan in New Mexico
63 TR4
As he stared at her ample bosom, he daydreamed of the dual Stromberg
carburetors in his vintage Triumph, highly functional yet pleasingly formed,
perched prominently on top of the intake manifold, aching for experienced
hands, the small knurled caps of the oil dampeners begging to be inspected and
adjusted as
described in chapter seven of the shop manual.
Dan McKay
************************************** Get a sneak peek of the all-new AOL at
http://discover.aol.com/memed/aolcom30tour
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|