OK everybody....on a TR3A, what's the trick to bending the short brake lines
that run from the master cylinders to the fluid reservoir? I got new lines
from Moss (1/4" stuff), but they're so stiff I can't bend them without getting
a horrible looking line full of kinks and dents. I have tried 3 different
bending tools and a lot of patience, wore my fingers out, and I still had no
luck....there are some tight bends in those lines. Is there better
material...something that's a little softer and easier to bend? Or maybe
somebody has a "secret method" to bend these things without collapsing them?
Fill 'em with sand first?
If you respond, please cc my home email too because I get the list as a
digest.
Thanks,
Steve Ball
Lompoc Ca
banjonut@verizon.net
'60 TR3A
TS68164L
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|