> When balancing the carburettors, Bentley says to loosen the
> interconnection, and balance at 850 RPM and re tighten. Then
> it says to
> bring the engine to 1500rpm and re balance with the idle adjusting
> screws. Do I loosen the interconnection again when I do
> this?
I believe the answer is "no". Sounds to me like the second step involves
adjusting the "idle trim screws" that bleed air around the throttle plates,
rather than the position of the throttle plate.
> It then
> says to balance with the choke on. Once again, do I loosen the
> connector?
Are you sure this third step isn't talking about adjusting the choke
(starting bar) itself ? In any case, I'm pretty sure you don't loosen the
clamp again, the clamp stays at the setting determined in step one.
But I don't have a TR6 Bentley handy (and my home computer is on the fritz),
so I'm just guessing.
Randall
(Tedious but unavoidable disclaimer follows)
CONFIDENTIALITY. This electronic mail and any files transmitted with it may
contain information proprietary to NavCom Technology, Inc., or one of its
affiliates, and are intended solely for the use of the individual or entity to
whom they are addressed, shall be maintained in confidence and not disclosed to
third parties without the written consent of the sender. If you are not the
intended recipient or the person responsible for delivering the electronic mail
to the intended recipient, be advised that you have received this electronic
mail in error and that any use, dissemination, forwarding, printing, or copying
of this electronic mail is strictly prohibited. If you have received this
electronic mail in error, please immediately notify the sender by return mail.
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|