> > One respected advice-giver said " .. can't be done .. it's
> pot metal
I am reasonably certain that SU carbs are not "pot metal". Don't exactly
what alloy it is, but it's primarily aluminum, not zinc.
> The commercial says you can repair any Al alloy with these
> rods and a propane torch. No flux reqired. Just a clean surface.
>
> Has anyone ever used this product? and on SUs?
I've tried it on a thermostat housing; couldn't make it work. My propane
torch was woefully inadequate to heat the housing to the required
temperature; even after 15 minutes on the same spot.
Never tried an SU body, though.
Randall
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|