I have used a standard foam tape with stickum on one side, available
at most auto parts stores.
Bill
On Jun 16, 2007, at 12:21 PM, Mike Denman wrote:
> What is everyone using to seal the transmission cover to the floor
> and bulkhead? I spent a couple of hours last weekend getting the
> transmission cover off of out TR3. The previous owner had used
> silicone sealer under the flanges and it was a struggle to get the
> cover loose. I would like something that sealed out the water, oil,
> dirt, fumes etc. but was still easy to remove for maintenance. I
> noticed that TRF (part# GCS6) and Moss (part# 680-428) have rubber
> seal kits for the TR4. Do these fit the TR3? Our TR3 has a metal
> transmission cover. Any other suggestions?
> Mike Denman
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|