RE: [TR] Differential pinion end float

["Randall" <tr3driver@ca.rr.com>]

> Has anyone adjusted the differential pinion end float by the
> method in the link below?  All comments welcome?
> http://bernardembden.com/xjs/diff/index.htm

I haven't, but it sounds reasonable under the circumstances described.  Only
potential problems I see are that it assumes the pre-load was zero at the
beginning, and the crush sleeve isn't already crushed too far.

Randall


===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org