On Friday 01 June 2007 11:49 am, barry papaleo wrote:
> I just picked up an unused top that has the tenax snaps installed, but I'm
> not sure if they are installed correctly. My old top had oval punch outs
> on the flap which the studs went through then connected to the snaps. On
> this one, there are no punch outs and the snaps were installed right
> through top layer and the flap making it kind of hard to hook up. Which is
> correct? (hope I've made it clear enough) TIA
>
Barry,
Every TR3 top I have seen has the snaps only through the top. The flap should
just have holes punched out where the snap male and female unite.
I would remove the snaps and re-install only throuth the "TOP".
Bob
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|