[TR] Inertia seat belt and roll bar installation conflict

["Wages, Jeffrey \(CDC/CCID/NCID\)" <bzw8@cdc.gov>]

Hi all,

As I went to install a new (but used) roll bar in my TR6, I discovered
that the over the shoulder inertia seatbelt housings would not allow the
roll bar to be installed. I assume that they must go or be moved and I
wondered if anyone knew what the best, tried and true, option may be.

Any ideas?

Thanks,

Jeff
Atlanta


===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org